Reframing the problem: A unique design for cantilever support

Recently, a client came to us with a difficult design problem. A building the client was constructing needed a cantilever beam to support the roof. Unfortunately, there was very little head clearance, and therefore not enough space to place a steel cantilever beam under the roof joists.

This required innovation.

The solution: A unique framing design that could provide adequate support while also providing enough head clearance. A traditional cantilever support consists of a beam that sits beneath the roof joists. In our design, the joists are made of 2 x 12 lumber which is notched to allow the steel beam to fit inside the joists, rather than sitting underneath them. This significantly increases the clearance of the beam.

9534_3350 Walnut St_Structural._zoomed.jpg
cantilever

This framing design allowed the client to proceed with the project.

As a client you may have design challenges that require a unique solution. At Engineering Studio Denver we are always up to the task. There is nothing we love more than a good engineering challenge! Call us today to discuss your project’s engineering needs.